EXCEEDS THE EXPECTATIONS

 

 

GI and PVC Pipes

...............................................................................................

A Pipe For all Application

...............................................................................................

Pipe of this Generation

...............................................................................................

Just Like Copper

Products

......................................................................................................................................................................................................................................................................................................................

Vista PE-AL-PE Multilayer Composite pipe
JUST DONT COMPARE

PIPES:

The following are the range of Vista PE-AL-PE multilayer composite pipe.

Size Range

Inner Diameter

Outer Diameter

1014

10mm

14mm

1216

12mm

16mm

1418

14mm

18mm

1620

16mm

20mm

2025

20mm

25mm

2532

25mm

32mm

3240

32mm

40mm

4150*

41mm

50mm

5163*

51mm

63mm

6075*

60mm

75mm

*Available on request

Even in conditions where water is subject to freezing, Vista PE-AL-PE Multilayer composite pipes can withstand water at temp up to -40C due to their Frost Resistance characteristics.
Vista PE-AL-PE Multilayer composite are suitable for long term extrusion of hot water up to 90C due to their low Thermal Conductivity.

The middle layer of aluminum enables Vista PE-AL-PE Multilayer composite to withstand high working pressure and ensures no gas or oxygen permeability.

Compression or Screw Fittings

Compression Fittings combine the positive feature of high reliability with a simple installation technique. The fittings do not require any special tools. The permanent pipe joint is achieved by compression i.e. by tightening the nut against the coned-shaped olive. The profiles of the two pieces are designed to cause a progressive shrinkage of the coned-shaped olive and to distribute the compression forces across the contact surface. Seal housing has been designed with a special slip-proof profile called O-rings that come into direct contact with the pipe. The simplicity and economic aspect of this system is based on the use of spanners, standardized threads (GAS ISO), which make it possible to connect with any system.

Advantages of Screw Fittings

Developed with advance forging technique.

Easy and convenient installation.

Optimized structure design

TOOLS:

The following are the tools used with vista PE-AL-PE multilayer composite pipe,
 

Vista Tools Description

Pipe cutter

Capable of cutting pipes ranging from 1014 to 6075, normally used for pipes of sizes no smaller than 3240.

Plastic reamer

For rounding pipes of sizes no bigger than 2632 in F1 fitting installation

Reamer

For beveling and rounding pipes of sizes no bigger than 2632 in (F5)press fitting installation.

Bending spring

For corresponding pipes.  1014 to 3240